 |
| foam model ready to be dipped in paint. white model white paint but it should improve the texture and stop the polystyrene flaking all over the place. |
 |
| another foam model. here you can see the raised viewfinder and angled cutaway for the shutter release. the near bottom corner is rounded to make using the lens easier. |
 |
| the two models after a couple of dips in the paint. its quite a nice texture to hold. |
 |
| some card shoe inserts i saw outside a shop on the way to college. going to try moulding a camera from it. |
 |
| got some marker on it. |
 |
| same one again. the join line around the camera is so heavy because i intend to have the internal chassis show through where the two halves of the camera meet. |
 |
| soaking some of the shoe card in water. in the left are two halves of a foam camera to mould it onto. |
 |
| went alright. ill see on monday when its dry. hard to work it without it just falling apart. |
 |
| shot of the back of the camera. on the right is the thumbwheel for shutter speed. in the middle is a slide for iso. havent fully worked this out yet but if iso is just ramping up the gain the could that be controlled by a slide potentiometer? next is the white balance. daylight in the middle and one filter each side. |
